Reolink PoE Security Camera 5MP Super HD with Human/Vehicle Detection, Support Audio Dome Outdoor Indoor Home CCTV Camera IP66 Waterproof IP Camera RLC-520A 2Pack

Product Information

If you fail to add Reolink cameras to Synology, please follow the below steps to make troubleshoot. If you just received your new camera and are not familiar with the camera, you can have a look at the below video about the unboxing, setup, and installation of the camera. However, these cameras can work with this integration through an NVR in which the NVR is connected to Home Assistant. After plugging the new camera to the NVR, the camera's image does not show up on the monitor and it prompts "video loss". The following troubleshooting may be helpful to you.

Unsurprisingly, the Reolink RLC-520A shares the same design with the RLC-520 since it’s supposed to be a replacement for the older series. iSpyConnect has no affiliation, connection, or association with Reolink’s products. The connection details provided here are crowd sourced from the community and may be incomplete, inaccurate or out of date. We provide no guarantee or warranty that you will be able to connect to your cameras using these URLs. I have been using Reolink cameras for about 2 years connected to Synology Surveillance Station (SSS). About 6 months ago I upgraded my 4 cameras to RLC 520a's as I really wanted the person detection features. With the latest firmware this works beautifully with SSS - triggering it correctly according to my camera settings.The latency for receiving the events is the best for ONVIF push and the worst for fast polling, the fastest available method that is detected to work will be used, and slower methods will not be used.

For redundancy, these sensors are polled every 60 seconds together with the update of all other entities. There are several possible causes for Micro SD Card Not being Detected on Reolink App. You may follow the troubleshooting tips listed below to solve the problem. If an entity listed below has an asterisk (*) next to its name, it means it is disabled by default. To use such an entity, you must enable the entity first. Number entities Do not point the camera toward a glass window. Or, it may result in poor image performance due to the window glare from infrared LEDs, ambient lights or status lights. However I discovered that the sound and audio were gradually drifting out of sync - up to about 4 seconds apart. The video is lagging behind the audio. This means that not only is the recording out of sync but also the snapshot starts to miss the event due to the video lagging. If I disable and re-enable the camera in SSS it is all great again but then the drift starts again.The last4 are the last 4 digits of the QR code which is printed (on the underside) of the camera itself. Furthermore, the RLC-520A also relies on the 5-megapixel sensor and the 2560 x 1920 (Super HD) resolution to give you a crystal clear look not only during the day, but also during the night (the IR vision can go up to 100 feet before some noise creeps in). And if that sounds an awful lot like the Reolink RLC-510A, well, it’s because they’re essentially the same device, but with a different skin. When IR light entity is OFF always OFF, when ON IR LEDs will be on when the camera is in night vision mode, see the Day night mode select entity. Sensor entities ONVIF push will result in slightly faster state changes of the binary motion/AI event sensors than ONVIF long polling.

Please install the waterproof lid at the junction of the Ethernet cable and the camera to protect the junction from water.Step 1. Use the mounting hole template to drill mounting holes on the ceiling, and plant the rubber anchoring into the mounting holes. These models are discontinued and not sold anymore, they will continue to work with Home Assistant. Step 1. Use the mounting hole template to drill mounting holes on the ceiling, and plant the rubber anchorings into the mounting holes.